Embedded Files
This is a simple network with 6 PCs, 2 switches, and a routers. A proper cable was placed to connect the PCs to the switches. And proper cables was placed to connect a PC and router to each switch. Afterwards I configured the workstation and router IP address information. Finally, tested connectivity using the Ping command.
This topology (using only straight-through cable and FastEthernet ports).
This topology (using only straight-through cable and FastEthernet ports).
Router was configured by going to router and clicking the config tab. On this tab you can change the Display Name and Hostname of the router.
Router was configured by going to router and clicking the config tab. On this tab you can change the Display Name and Hostname of the router.
On FastEthernet0/0 interface on left and I configured the router with the IP address information. FastEthernet1/0 was also configured with the same procedure.
On FastEthernet0/0 interface on left and I configured the router with the IP address information. FastEthernet1/0 was also configured with the same procedure.
Connectivity was tested by pinging PC3 from computer PC0
Connectivity was tested by pinging PC3 from computer PC0
Page updated
Google Sites
Report abuse